1974 Honda Wheel Alignment Guide

HONDA SPECIFICATIONS AND ADJUSTMENTS

TIRE INFLATION (COLD)
Before checking or adjusting wheel alignment, make sure tires are correctly inflated. Refer to manufacturers specifications located in glove box.

RIDING HEIGHT
Make sure tires are properly inflated. Measure from bottom side marker lamps to ground. This distance should be 25.78" in front and 24.01" in rear. NOTE - If height measurement is not within specifications, check rear height before attempting to repair front suspension.

CASTER
Caster is nonadjustable. If alignment is not within specifications, inspect for damaged parts and replace as necessary.

CAMBER
Camber is nonadjustable. If alignment is not within specifications, inspect for damaged parts and replace as necessary.

TOE-IN
To adjust toe-in, loosen lock nuts at each of the tie rods. To increase toe-in, turn the right tie rod in the direction of wheel rotation when the car4 moves forward and turn the left tie rod in the opposite direction. Turn both tie rods an equal amount until toe-in is within specifications. Tighten lock nuts of each tie rod.


◄ Newer Post Older Post ►
eXTReMe Tracker
 

Copyright 2011 Car Repair Man is proudly powered by blogger.com